D80+K - Box for two Floppy drive with electronics
BOX INTRODUCTION:

Plastic box for two 3.5 inch Floppy disc drive; made by 3D printing, Material: Various color PLA

This box is primarily intended for D80+K Interface. Mechanically, it is designed for two 3.5" floppy disc drive and for PCB with electronics.


ELECTRONICS INTRODUCTION:

Splits a data BUS from the D80+K controller (IBM type) to two floppy disk drives. It includes power regulator from 7,5-12V to 5V/4A (power for 2x FDD).


PARAMETERS:

• 1x Data BUS input from controller (rear connector IDC34)
• 2x Data BUS output to two floppy disk drive (top connectors IDC34)
• Each drive can be set as A or B
• The DS0 / DS1 selection for each of the drives is also set by the jumper switch
• input supply voltage +7,5-12V DC, 2,5A max.
• regulator LD1084V included

D80+K Box for two floppy drive
D80+K Box for two floppy drive
D80+K Box for two floppy drive
D80+K Box for two floppy drive